The automatic forming machine of fully active block forming machine can process industrial wastes such as tailings slag, ceramsite, perlite (urban construction waste), sand, stone powder, fly ash, cinder, coal gangue and so on into various new wall materials, such as hollow cement blocks, porous bricks, standard bricks, etc., without sintering.
Equipment characteristics
1. According to the traditional custom of brick for wall in China, following or modelling standards, mechanical application saves time and effort, and planning is reasonable.
2. Compact structure, safe and reliable, rational use of a set of transmission mechanism, end a variety of process actions, simplify the mechanical structure, easy to maintain.
3. Exquisite production, product quality fault is less than 1%, strength fault is 0.5%.
4. High and low pressure, strong vibration, especially suitable for producing high-strength blocks, can be stacked after forming (3-5 layers).
5. The slag content is large, and the compressive strength of the product is over MU10.0.
6. A multi-purpose machine with different moulds can produce wall blocks of various standards and shapes.
7. Compared with similar equipment abroad, the price of this equipment is less than one tenth when the product quality, production ability and initiative are appropriate. It is an ambitious brick-making equipment suitable for China's national conditions.
purpose
The machine has the advantages of simple structure, compact structure, simple operation, easy maintenance, less hard work, high output value, small investment and quick return. It is very suitable for producing standard bricks. Its strength is higher than clay bricks. After replacing different moulds, various blocks can be produced. Produced blocks can be widely used: slag, sand, crushed stone, aluminium red slag, electrolytic copper slag, coal gangue, construction waste, fly ash, volcanic slag and other information are abundant and can be seen everywhere. It is extremely convenient to invest in the construction of factories.
Marked content
The product shall fix the product label in an obvious and appropriate direction, and its type and standard shall conform to the rules of JB8, and indicate the following contents: A. product name, model and standard code; B. factory number; C. factory date; D. manufacturer name; E. trademark. Packaging and random skill documentation should comply with JC/T406 rules. It is also accustomed to the requirements of land and water transportation. Before the installation is put into operation, both the manufacturer and the user should keep it properly to avoid rust damage and deformation.